Can You Use Weatherproof Sealant on a Metal Roof?
Yes. A quality weatherproof sealant stops metal roof leaks at screws, seams, and flashings. Fasteners are the number one leak source on corrugated and screw-down metal roofs. The washer cracks, the screw backs out, and water runs straight down the shank. A flexible sealant bead over each fixing closes that path for years. The trick is matching the chemistry to the panel and prepping each spot properly.

Weatherproof Sealant on Metal Roofs
Which Sealant Bonds to Metal
Metal roofs move. Panels expand in the sun and contract at night, so the bead must stay flexible. A neutral-cure weatherproof sealant or a hybrid MS polymer sealant grips coated steel, galvanized panels, and aluminium without corroding them. Avoid acidic cure silicones on bare metal because the acid etches the coating and shortens the bond life. Skip acrylic caulk outdoors entirely. It chalks under UV and splits within two seasons.
Sealing Roof Screws Step by Step
Work on a dry, overcast day and follow this order:
- Inspect: look for backed-out screws, cracked washers, and rust stains under the head.
- Replace: back out any damaged screw. Drive an oversized screw with a fresh washer beside it, not into the same hole.
- Clean: wire-brush rust and dust, then wipe with a degreasing cloth and let it dry.
- Seal: run a 10 to 15 mm cap of sealant over each screw head. Tool it down the panel ribs.
Overdriven screws crush the washer and leak no matter how much sealant you add. Back them off half a turn until the washer sits flat, then cap the head.
Seams, Ridges, and Flashings
Lap seams leak when wind-driven rain pushes water uphill through the overlap. Run a 5 to 8 mm bead along the lap edge and tool it into the joint. Ridge caps and flashings need a continuous bead along the fixing line. Add dabs every 20 cm on the closure strips. Keep joints shallower than 12 mm or use backer rod. A deep bead cures slowly and tears with panel movement.
When Sealant Is Not Enough
A bead fixes small, stable defects. Three cases need real repair first:
- Rust-through: pinholes across a panel mean the coating has failed. Cut out and patch the sheet before sealing.
- Soft structure: rotted purlins or sagging sheets need structural repair before any bead goes on.
- Steep or high roofs: anything above a 6/12 pitch or two storeys belongs to a licensed roofer.
The working summary: yes, weatherproof sealant belongs on metal roofs. Cap every screw head, seal lap seams at 5 to 8 mm, and replace damaged fasteners before you seal. Walk the roof once a year, because washer rubber ages faster than the panel. For cure timing, see how long weatherproof sealant takes to dry before the next rain check.
Related Products
![]() Weatherproof Sealant |
![]() General Purpose Silicone Sealant |


